진동 감시 시스템-알람/정지 (VIBER M2)
(Vibration guard system)
◆ 개요(Description)
▶ 하나의 진동센서만으로 진동, 베어링 상태 및 온도 모니터링
▶ 장애가 발생하고 경고 또는 위험에 대한 설정이 초과되면 시스템에서 경보를 발령하거나 시스템을 중지
▶ 기계 진동, 장비 및 원동기의 상태를 지속적으로 측정하며, 정보는 외부 PLC 에 의해 제어실로 전송 가능
▶ 3가지 측정 범위
▶ 수동 또는 자동 리셋 기능이 있는 두 개의 독립적인 알람 레벨 설정
▶ 진동 레벨을 4 ~ 20 mA에 비례하는 전류 출력, PLC등에 연결
▶ 사전 설정된 알람신호 레벨에 도달하면 LED 램프가 On
▶ 릴레이 (0-30초) 활성화 및 수동 또는 자동으로 알람 상태를 리셋
▶ 각종 장비의 고장 모니터링
▶ BNC 및 터미널 출력의 분석 신호
▶ 밀폐 함체: Enclosure Sealed (IP65) 보호등급
▶ 진동 및 또는 온도 상태, 경보 설정 및 경보 상태에 대한 개요를 보여주는 투명한 뚜껑이 달린 PVC박스
Channel card for accelerometers Input sensitivity |
Standard
100mV/g: The positive input terminal supplies a 4 mA constant current at max.
20V to the built in transducer amplifier. |
Frequency range |
2 ~
4000 Hz are pre set. The lowest frequency range can be changed to 10 Hz on
the pc-board. |
Analysis output |
100mV/g
between 2 ~15000 Hz. Min load 10kΩ. |
RMS Value |
The
instrument measures the RMS value of the signal within the selected frequency
range. |
Current output |
The
current output is 4-20 mA on pc-board. Maximum
load not more than 600 ohm or 12V. 20
mA refers to 100% of selected measuring range |
Time delay
|
The
time delay of relay activation is adjustable between 0 and 30 sec. |
Measuring range
|
Selectable
between 0-10, 0-20 or 0-100 mm/s. This
selection does not influence the sensitivity of the analysis output. |
Enclosure dimensions |
Width
170mm, height 160mm, depth 130mm |
Relay output and functions |
Single
pole over relay 5A/250VAC or 5A/24V. The
relay coils can be activated or deactivated below the alarm level. The
2-channel version has shared relays for both channels and the highest
level activates the relay. |
Power supply |
Standard
is 100-240VAC or 24VDC. |